Download Print this page

Advertisement

[Sysname-if-range] shutdown
[Sysname-if-range] quit
# Bind Ten-GigabitEthernet 2/3/0/1 through Ten-GigabitEthernet 2/3/0/4 to IRF-port 2/1.
[Sysname] irf-port 2/1
[Sysname-irf-port2/1] port group interface ten-gigabitethernet 2/3/0/1
[Sysname-irf-port2/1] port group interface ten-gigabitethernet 2/3/0/2
[Sysname-irf-port2/1] port group interface ten-gigabitethernet 2/3/0/3
[Sysname-irf-port2/1] port group interface ten-gigabitethernet 2/3/0/4
[Sysname-irf-port2/1] quit
# Bring up the IRF physical interfaces.
[Sysname] interface range ten-gigabitethernet 2/3/0/1 to ten-gigabitethernet 2/3/0/4
[Sysname-if-range] undo shutdown
[Sysname-if-range] quit
# Save the running configuration to startup configuration file.
[Sysname] quit
<Sysname> save
3.
Activate the configuration on IRF ports:
# Connect Device B to Device A as shown in
# Log in to Device A. (Details not shown.)
# Activate IRF port configuration on Device A.
<Sysname> system-view
[Sysname] irf-port-configuration active
# Log in to Device B. (Details not shown.)
# Activate IRF port configuration on Device B.
<Sysname> system-view
[Sysname] irf-port-configuration active
%Jul 9 09:04:48:279 2013 G2-16 STM/4/STM_MERGE_NEED_REBOOT: -MDC=1; IRF merge occurs
and the IRF system needs a reboot.
%Jul 9 14:03:06:855 2013 G2-16 STM/5/STM_MERGE: -MDC=1; IRF merge occurs and the IRF
system does not need to reboot.
# Reboot Device B.
[Sysname] quit
<Sysname> reboot
Device A and Device B form a two-chassis IRF fabric after Device B reboots. Device B is the
subordinate device.
4.
Configure BFD MAD:
# Create VLAN 3, and add Ten-GigabitEthernet 1/4/0/1 and Ten-GigabitEthernet 2/4/0/1 to
VLAN 3.
<Sysname> system-view
[Sysname] vlan 3
[Sysname-vlan3] port ten-gigabitethernet 1/4/0/1 ten-gigabitethernet 2/4/0/1
[Sysname-vlan3] quit
# Create VLAN-interface 3, and configure a MAD IP address for each member device on the
VLAN interface.
[Sysname] interface vlan-interface 3
[Sysname-Vlan-interface3] mad bfd enable
Figure
13.
37

Advertisement

Comments to this Manuals

Symbols: 0
Latest comments: