Changing The Priority Of A Member Device; Adding Physical Ports To An Irf Port - HP FlexFabric 12500 Series Configuration Manual

Step
1. Enter system view.
2. Change the member ID of a
member device.
3. Save the running
configuration.
4. Reboot the member device.

Changing the priority of a member device

You can change the priority of a member device so it can be elected the master at the next master
election.
A member priority change can affect the master re-election result, but does not cause immediate master
re-election.
To change the priority of a member device:
Step
1. Enter system view.
2. Specify a priority for a
member of an IRF fabric.

Adding physical ports to an IRF port

An IRF port can have up to 12 physical ports. In IRF mode, you can add more physical ports to an IRF port.
This task does not affect the ongoing traffic on the IRF port.
When you perform this task, follow the IRF physical port restrictions and configuration guidelines in
"MPU and IRF physical port
To configure IRF ports:
Step
1. Enter system view.
Command
system-view
irf member member-id renumber
new-member-id
save [ safely ] [ force ]
reboot chassis chassis-number
Command
system-view
irf member member-id priority priority
restrictions" and "Binding physical ports to IRF
Command
system-view
24
Remarks
N/A
N/A
N/A
The chassis-number must be the
same as the member-id specified
in the irf member member-id
renumber new-member-id
command.
Remarks
N/A
The default IRF member priority
is 1.
ports."
Remarks
N/A