Download Print this page

Advertisement

Slot 1:
Saving the converted configuration file succeeded.
Now rebooting, please wait...
Device B and Device A form a two-chassis IRF fabric after Device B reboots.
3.
Configure LACP MAD:
# Assign domain ID 1 to the IRF fabric.
<Sysname> system-view
[Sysname] irf domain 1
# Create a dynamic aggregate interface and enable LACP MAD.
[Sysname] interface bridge-aggregation 2
[Sysname-Bridge-Aggregation2] link-aggregation mode dynamic
[Sysname-Bridge-Aggregation2] mad enable
You need to assign a domain ID (range: 0-4294967295)
[Current domain is: 1]:
The assigned
MAD LACP only enable on dynamic aggregation interface.
[Sysname-Bridge-Aggregation2] quit
# Assign Ten-GigabitEthernet 1/4/0/2 and Ten-GigabitEthernet 2/4/0/2 to the aggregate
interface.
[Sysname] interface ten-gigabitethernet 1/4/0/2
[Sysname-Ten-GigabitEthernet1/4/0/2] port link-aggregation group 2
[Sysname-Ten-GigabitEthernet1/4/0/2] quit
[Sysname] interface ten-gigabitethernet 2/4/0/2
[Sysname-Ten-GigabitEthernet2/4/0/2] port link-aggregation group 2
[Sysname-Ten-GigabitEthernet2/4/0/2] quit
4.
Configure Device C as the intermediate device:
CAUTION:
If the intermediate device is also an IRF fabric, assign the two IRF fabrics different domain IDs for
correct split detection. False detection causes IRF split.
# Create a dynamic aggregate interface.
<Sysname> system-view
[Sysname] interface bridge-aggregation 2
[Sysname-Bridge-Aggregation2] link-aggregation mode dynamic
[Sysname-Bridge-Aggregation2] quit
# Assign Ten-GigabitEthernet 4/0/1 and Ten-GigabitEthernet 4/0/2 to the aggregate interface.
[Sysname] interface ten-gigabitethernet 4/0/1
[Sysname-Ten-GigabitEthernet4/0/1] port link-aggregation group 2
[Sysname-Ten-GigabitEthernet4/0/1] quit
[Sysname] interface ten-gigabitethernet 4/0/2
[Sysname-Ten-GigabitEthernet4/0/2] port link-aggregation group 2
[Sysname-Ten-GigabitEthernet4/0/2] quit
domain ID is: 1
34

Advertisement

Comments to this Manuals

Symbols: 0
Latest comments: