Table of Contents
Advertisement
Setup
USB Software Update
The Maverick Force 1 Spot allows for software update through USB using the built-in USB port. To update
the software using a USB type C flash drive, do the following:
1. Power on the fixture and plug the flash drive into the USB port.
2. Once the flash drive has been detected, the message "Upgrade Firmware" will be displayed.
Press <ENTER>. If a different message appears on the display, search for the update software in
the main menu (Upgrade Firmware) and select from Only This Fixture, Multiple Fixture, or
Other Fixture Type. A list of the software update files will be displayed.
3. Select the file that needs to be uploaded. The message "Are you sure?" will be displayed. Press
<ENTER>.
If the selected file is incorrect, the upgrade will fail, and the display will go back to the
main interface. Repeat steps 1-3 using the correct file.
4. If the selected file is correct, the upgrade will start. DO NOT turn off the power or disconnect the
USB during the process. USB update can take several minutes to complete.
5. When the update is completed, the fixture will automatically reboot.
6. Go to the Fixture Information on the product's menu map and confirm the firmware revision
7. When the boot-up process is finished, restart the product.
•
Place the .chl format file in the root folder of the USB drive.
•
The product's USB port supports up to 32GB capacity and only works with FAT32 file
format.
Maverick Force 1 Spot User Manual Rev. 7
7
Advertisement
Table of Contents
