Adding Peripheral Drives - Supero SUPERSERVER AS-4021GA-62R+F User Manual

SUPERSERVER AS-4021GA-62R+F User's Manual

Adding Peripheral Drives

You can add up to three peripheral drives (DVD-ROM, CD-ROM, fl oppy drive, etc.)
to the drive trays using the procedure below.
Adding Peripheral Drives
1. Open the chassis cover.
2. Locate the drive tray release tab for the slot you want to place the peripheral
drive.
3. Push the drive tray toward the front of the chassis.
4. Remove the hard drive tray rails from the hard drive tray. To do this, you must
remove two screws from each side (see Figure 6-12).
5. Attach the rails to a DVD-ROM, CD-ROM, fl oppy drive, or other peripheral.
The rails should fi t any standard sized peripherals.
6. Slide the peripheral into the chassis until the tray clicks into place.
7. Repeat these steps for each hard drive tray.
Figure 6-12: Adding Hard Drive Rails to the DVD-ROM Drive
Hard Drive Rails
6-12
Hard Drive Tray