Adding Five Hard Drives Using A Supermicro Mobile Rack - Supero SUPERSERVER AS-4021GA-62R+F User Manual

Adding Five Hard Drives Using a Supermicro Mobile Rack

The SC747 chassis accepts a CSE-M35S (SCSI) or CSE-M35T-1/CSE-M35TQ
mobile rack to install extra hot swappable hard drives. The mobile rack goes into
the storage module which goes into the chassis.
For more information on mobile rack installation and use, refer to the appendix
located at the end of this manual.
Adding Hard Drives to a Supermicro Mobile Rack
1. Open the chassis cover.
2. Locate the drive release tabs.
3. Pull the fi rst drive release tab and push the drive tray toward the front of the
chassis. Repeat this for all three tabs.
4. Remove the hard drive tray rails from the hard drive tray. To do this, you must
remove two screws from each side. Do this for all three hard drive trays. See
Figure 6-11 for details.
5. Attach the rails to a DVD-ROM, CD-ROM, fl oppy drive, or other peripheral.
The rails should fi t any standard sized peripherals.
6. Install all six hard drive rails to the mobile rack. Each individual rail requires
two screws. Also, make sure the arrow on the rail points toward the front of
the chassis (see Figure 6-13).
7. Slide the mobile rack into the storage module and chassis.
Figure 6-13: Adding Hard Drive Rails to a Storage Rack
Mobile Rack
Chapter 6: Advanced Chassis Setup
6-13
Hard Drive
Rails