Supero SUPERSERVER AS-4021GA-62R+F User Manual page 64

SUPERSERVER AS-4021GA-62R+F User's Manual
Compact Flash Master/Slave Select
A Compact Flash Master (Primary)/Slave
(Secondary) Select Jumper is located at
JCF1. Close this jumper to enable Compact
Flash Card. For the Compact Flash Card
or the Compact Flash Jumper (JCF1) to
work properly, you will need to connect the
Compact Flash Card power cable to JWF1
fi rst. Refer to the board layout below for the
location.
Audio Mode Select
Jumper JL2 allows you to select the Audio
mode. You can choose using AC '97 Audio or
HD (High-defi nition) Audio. The default set-
ting is Open to use HD Audio. See the table
on the right for jumper settings.
IEEE 1394 Firewire Enable/Disable
Jumper JPI1 allows you to enable or disable
the IEEE 1394 Firewire ports. See the table
on the right for jumper settings. The default
setting is enabled.
Compact Flash Card Master/
Slave Select (JCF1)
Jumper Setting
Open
Closed
Audio Mode Select
Jumper Settings
Jumper Setting Defi nition
Closed
Open
IEEE 1394 Firewire
Jumper Settings (JPI1)
Jumper Setting Defi nition
Pins 1-2
Pins 2-3
5-28
Defi nition
Slave (Secondary)
Master (Primary)
AC'97 Panel
HD Audio (Default)
Enabled
Disabled