Installation; Installation Procedure - JCM ivizion ld Operation And Maintenance

Next-Generation Banknote Acceptor Unit

2 INSTALLATION

This section provides installation and operating
instructions for the iVIZION
tion Banknote Acceptor Unit. The information
within this section contains the following features:
•

Installation Procedure

•
DIP Switch Configurations
•
Connector Pin Assignments
•
Preventive Maintenance
•
Cleaning Procedure
•
Standard Interface Circuit Schematics
•
Operation Flowcharts
Installation Procedure
Mounting holes are provided in each Frame Unit to
attach the iVIZION to a related Machine during
installation. Select and perform the following steps
to install the iVIZION Unit in the related
Machine's particular Frame configuration:
1. Install the Interface Harness to the Frame
Grounding Plate (FG PLT) (Figure 2-1 a) using
the two (2) Floating Collars (Figure 2-1 b), the
single (1) M2.6x12 W Washer Screw (Figure 2-1
c), the single (1) M2.6x10 W Washer Screw (Fig-
ure 2-1 d) and the single (1) M2.6 Nylon Nut
(Figure 2-1 e) onto the Frame Assembly. See the
Figure 2-1 circled inset to visually see the assem-
bly completed as required.
Figure 2-1 Interface Harness Installation Loca-
tion
b
c
b
d
Figure 2-1 Interface Harness Installation Location
P/N 960-100929R_Rev. 7 {EDP #148849}
iVIZION® Series
S e c t i o n 2
Series Next-Genera-
®
a
e
2. When a side mounting configuration is preferred,
bolt the left and right side of the
Frame into its intended
tion using six (6) M4 Screws on both sides of the
Frame (3 Screws on each side as shown in Figure
2-2).
Figure 2-2 M4 Screws Locations (Left/Right
Side)
Figure 2-2 M4 Screws Locations (Left/Right Side)
3. When an end mounting configuration is pre-
ferred, remove the Cash Box and attach the rear
iVIZION
end of the
location using four (4) UNC6-32 Flat Head
Screws from inside the back end of the Frame as
shown in Figure 2-3.
Figure 2-3 Flat Head Screws Locations (Rear
Side)
Figure 2-3 Flat Head Screws Locations
(Rear Side)
© 2017, JAPAN CASH MACHINE CO., LTD.
2 - 1
iVIZION
related Machine's
loca-
Frame into its intended