Configuring Basic Ospfv2; Enabling The Ospfv2 Feature - Cisco Nexus 7000 Series Configuration Manual

Configuring Basic OSPFv2

S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
•
•
•
•
•

Enabling the OSPFv2 Feature

You must enable the OSPFv2 feature before you can configure OSPFv2.
BEFORE YOU BEGIN
Ensure that you are in the correct VDC (or use the switchto vdc command).
SUMMARY STEPS
1.
2.
3.
4.
DETAILED STEPS
Command
Step 1
config t
Example:
switch# config t
switch(config)#
Step 2
feature ospf
Example:
switch(config)# feature ospf
Step 3
show feature
Example:
switch(config)# show feature
Step 4
copy running-config startup-config
Example:
switch(config)# copy running-config
startup-config
Use the no feature ospf command to disable the OSPFv2 feature and remove all associated
configuration.
Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration Guide, Release 4.x
6-14
Configuring Optional Parameters on an OSPFv2 Instance, page 6-16
Configuring Optional Parameters on an OSPFv2 Instance, page 6-16
Configuring Networks in OSPFv2, page 6-17
Configuring Authentication for an Area, page 6-19
Configuring Authentication for an Interface, page 6-21
config t
feature ospf
show feature
copy running-config startup-config
Purpose
Enters configuration mode.
Enables the OSPFv2 feature.
(Optional) Displays enabled and disabled features.
(Optional) Saves this configuration change.
Chapter 6 Configuring OSPFv2
OL-20002-02