Vrrp Operation - Cisco Nexus 7000 Series Configuration Manual

Information About VRRP
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
•

VRRP Operation

A LAN client can determine which router should be the first hop to a particular remote destination by
using a dynamic process or static configuration. Examples of dynamic router discovery are as follows:
•
•
•
The disadvantage to dynamic discovery protocols is that they incur some configuration and processing
overhead on the LAN client. Also, in the event of a router failure, the process of switching to another
router can be slow.
An alternative to dynamic discovery protocols is to statically configure a default router on the client.
Although, this approach simplifies client configuration and processing, it creates a single point of
failure. If the default gateway fails, the LAN client is limited to communicating only on the local IP
network segment and is cut off from the rest of the network.
VRRP can solve the static configuration problem by enabling a group of routers (a VRRP group) to share
a single virtual IP address. You can then configure the LAN clients with the virtual IP address as their
default gateway.
Figure 20-1
The IP address of the group is the same address that was configured for the Ethernet interface of Router
A (10.0.0.1).
Figure 20-1
Client 1
Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration Guide, Release 4.x
20-2
Virtualization Support, page 20-6
Proxy ARP—The client uses Address Resolution Protocol (ARP) to get the destination it wants to
reach, and a router will respond to the ARP request with its own MAC address.
Routing protocol—The client listens to dynamic routing protocol updates (for example, from
Routing Information Protocol [RIP]) and forms its own routing table.
ICMP Router Discovery Protocol (IRDP) client—The client runs an Internet Control Message
Protocol (ICMP) router discovery client.
shows a basic VLAN topology. In this example, Routers A, B, and C form a VRRP group.
Basic VRRP Topology
Router A Router B
Virtual router Virtual router
master backup
10.0.0.1 10.0.0.2
Client 2
Router C
Virtual router
Virtual
backup
router group
IP address = 10.0.0.1
10.0.0.3
Client 3
Chapter 20 Configuring VRRP
OL-20002-02