Displaying Vrrp Statistics; Vrrp Example Configuration - Cisco Nexus 7000 Series Configuration Manual

Displaying VRRP Statistics

S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
Command
show vrrp vr number interface interface-type
port configuration
show vrrp vr number interface interface-type
port status
Displaying VRRP Statistics
To display VRRP statistics, use the following commands:
Command
show vrrp vr number interface interface-type
port statistics
show vrrp statistics
Use the clear vrrp statistics command to clear all the VRRP statistics for all interfaces in the device.
Use the clear vrrp vr command to clear the IPv4 VRRP statistics for a specified interface.
Use the clear vrrp ipv4 command to clear all the statistics for the specified IPv4 virtual router.

VRRP Example Configuration

In this example, Router A and Router B each belong to three VRRP groups. In the configuration, each
group has the following properties:
•
•
•
Router A
interface ethernet 1/0
ip address 10.1.0.2/16
Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration Guide, Release 4.x
20-20
Group 1:
Virtual IP address is 10.1.0.10.
–
Router A will become the master for this group with priority 120.
–
Advertising interval is 3 seconds.
–
Preemption is enabled.
–
Group 5:
Router B will become the master for this group with priority 200.
–
Advertising interval is 30 seconds.
–
Preemption is enabled.
–
Group 100:
– Router A will become the master for this group first because it has a higher IP address
(10.1.0.2).
Advertising interval is the default 1 second.
–
Preemption is disabled.
–
Chapter 20
Purpose
Displays the virtual router configuration for an
interface.
Displays the virtual router status for an interface.
Purpose
Displays the virtual router information.
Displays the VRRP statistics.
Configuring VRRP
OL-20002-02