Toshiba QOSMIO G10 Maintenance Manual page 78

2 Troubleshooting Procedures
Table 2-4 Debug port (Boot mode) error status (5/8)
D port status
F106h Saving memory configuration to
buffer
Reading of EC version
Update of flash ROM type
Judging of destination (Japan or
except Japan) based on DMI
data
CMOS default setting check
ACPI table initialization (for
execution of option ROM)
Initialization of devices which
need initialization before PCI
bus initialization
PIC initialization
PIC test
Password Initialization
F107h PCI bus initialization
Initialization of LAN information
Check of WakeUp factor
F108h Task generation for waiting
INIT_PCI completion
CMOS data initialization (2)
PnP initialization
Setting of setup items
H/W setting based on resource
F109h Task generation for waiting PnP
resource making completion
PnP H/W initialization
PCI automatic configuration
QOSMIO G10 Maintenance Manual (960-497)
Inspection items
2.4 System Board Troubleshooting
Details
Defaults set if bad battery, bad checksum (ROM,
CMOS) is detected)
AC'97 control
Initialization of temperature control information
KBC initialization
VGA display off, Reset control
Sound initialization
HC initialization, USB Device recognition and
initialization
Control of built-in LAN permission/prohibition
(connection of DS Bus)
PC card slot initialization
Making of work for automatic configuration
Acquisition of PCI IRQ
2-25