Toshiba QOSMIO G10 Maintenance Manual page 218

3 Tests and Diagnostics
(b) HDD Boot Priority
Use this option to set the booting priority from HDD.
Built in HDD1→Built in HDD2 (Default)
Built in HDD2→Built in HDD1
NOTE: When 2nd HDD is not installed, this option does not appear in the menu.
If the boot command can not be detected from the prior HDD, booting target
changes to other devices.
(c) Network Boot Protocol
Use this option to set the starting method via a network.
PXE Sets to PXE protocol. (Default)
RPL Sets to RPL protocol.
6. Others
Whether or not you need to configure the computer with these options depends
primarily on the kind of software or peripherals you use.
(a) CPU Cache
Use this option to enable or disable the CPU cache.
Enabled
Disabled
(b) Level 2 Cache
Use this option to enable or disable the level 2 cache. When "CPU Cache" is
set to "Disabled", this option cannot be changed.
Enabled
Disabled
(c) Dynamic CPU Frequency mode
Use this option to choose a setting from the followings. When the CPU of the
computer is Celeron-M, this option is not displayed.
QOSMIO G10 Maintenance Manual (960-497)
: Searching boot-command from Built in HDD1
: Searching boot-command from Built in HDD2
Enables the CPU cache. (Default)
Disables the CPU cache.
Enables the level 2 cache. (Default)
Disables the level 2 cache.
3.31 SETUP
3-97