Floor covering
HP recommends the use of a tiled raised floor.
CAUTION:
HP strongly discourages the use of carpeting, including antistatic varieties, within 6.0 m
(20 ft.) of the disk array. Over time, carpeting may shed dust that can cause problems
with the disk array.
CAUTION:
If your computer room has carpeting, place static discharge mats so that personnel
must walk across them before touching any part of the array. Failure to comply with this
precaution can result in equipment damage through static discharge.
Floor cutouts
The following two figures show the locations of floor cutouts under the DKC and DKU.
Basically, position floor cutouts toward the center of the cabinet. The position may be
off-center as long as the cutout is within the allowable range and allows smooth entrance
of an external cable (check the relationship between the position of the cutout and the
opening on the bottom of the cabinet).
HP StorageWorks XP12000 Disk Array
29