Step 2: Prepare Your Site; Provide Adequate Structural Support For The Floor; Provide Adequate Clearance Space And Ventilation; Provide Adequate And Redundant Sources Of Power - HP 353803-B22 - StorageWorks Modular Smart Array 1000 SAN Starter Installation Manual

Step 2: Prepare your site

To ensure continuous, safe, and reliable operation of your equipment, place your system in an
approved environment. You must provide adequate physical space, ventilation, and power.
NOTE: Consider using the HP Enterprise Configurator (eCO) to help you plan and configure racks
and rack-mountable devices. The eCO is available on the HP website:
http://h30099.www3.hp.com/configurator.
In addition to the following discussion, see
detailed list of site requirements.

Provide adequate structural support for the floor

Calculate the total weight of your equipment and verify that your site can support the weight.

Provide adequate clearance space and ventilation

Be sure to provide adequate clearance around the front and back of the racks. Provide at least 25
inches (63.5 cm) in the front of the rack to allow the doors to open fully and provide at least 30
inches (76.2 cm) in the rear of the rack to allow for servicing and airflow.
If there are unused spaces in your rack, attach blanking panels across those empty spaces, to force
the airflow through the components instead of through the open spaces.

Provide adequate and redundant sources of power

Make sure that you have two high-line power feeds installed near your computer. These two power
sources usually come from the same external power grid, but occasionally may originate from
different grids or even different sources.
Obtain and include two UPSs in your installation for protection against a power-source failure.
28 Installation procedures—All deployments
Table 1, "MSA1000 specifications" on page 29 for a