Card Reader Board - HP EliteBook x360 1030 G2 Maintenance And Service Manual

Card reader board

Description
Card reader board
NOTE: The card reader board spare part kit does not include the card reader board cable. The card
reader board cable is included in the Cable Kit, spare part number 917893-001.
Before removing the card reader board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the card reader board:
1. Release the ZIF connector (1) to which the NFC board cable is attached, and then disconnect the NFC
board cable from the card reader board.
2. Release the ZIF connector (2) to which the card reader board cable is attached, and then disconnect
the card reader board cable from the card reader board.
3. Remove the three Philllips PM2.0×2.4 screws (3) that secure the card reader board to the keyboard/top
cover.
4. Remove the card reader board cable (4).
Reverse this procedure to install the card reader board.
42 Chapter 5 Removal and replacement procedures
Bottom cover on page
Battery on page 29).
27).
Spare part number
917892-001