Nfc Board - HP EliteBook x360 1030 G2 Maintenance And Service Manual

NFC board

Description
NFC board
NOTE: The NFC board spare part kit does not include the NFC board cable. The NFC board cable is
included in the Cable Kit, spare part number 917893-001.
Before removing the NFC board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the NFC board:
1. Release the ZIF connector (1) to which the NFC board cable is attached, and then disconnect the NFC
board cable from the card reader board.
2. Release the grounding tape (2) that secures the NFC board cable to the NFC board.
3. Release the ZIF connector (3) to which the NFC board cable is attached, and then disconnect the NFC
board cable from the NFC board.
4. Detach the NFC board (4) from the keyboard/top cover. (The NFC board is attached to the keyboard/top
cover with double-sided adhesive.)
5. Remove the NFC board.
Reverse this procedure to install the NFC board.
40 Chapter 5 Removal and replacement procedures
Bottom cover on page
Battery on page 29).
27).
Spare part number
917894-001