Audio Jack Board - HP EliteBook x360 1030 G2 Maintenance And Service Manual

4. Detach the fingerprint reader board (4) from the keyboard/top cover. (The fingerprint reader board is
attached to the keyboard/top cover with double-sided adhesive.)
5. Remove the fingerprint reader board.
Reverse this procedure to install the fingerprint reader board.

Audio jack board

Description
Audio jack board (includes cable)
Before removing the audio jack board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
a. Battery (see
b. Solid-state drive (see
c. Fan (see
d. Speakers (see
e. System board (see
Remove the audio jack board:
1. Remove the Philllips PM2.0×2.4 screw (1) that secures the audio jack board to the keyboard/top cover.
2. Lift the left side of the audio jack board (2) until it rests at an angle.
50 Chapter 5 Removal and replacement procedures
Bottom cover on page
Battery on page 29)
Solid-state drive on page
Fan on page 34)
Speakers on page 35)
System board on page
27), and then remove the following components:
30)
43)
Spare part number
917890-001