Thermal Sensor Board - HP EliteBook x360 1030 G2 Maintenance And Service Manual

Thermal sensor board

Description
Thermal sensor board (includes cable and double-sided adhesive)
Before removing the thermal sensor board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
Remove the thermal sensor board:
1. Release the zero insertion force (ZIF) connector (1) to which the thermal sensor board cable is attached,
and then disconnect the thermal sensor board cable from the system board.
2. Detach the thermal sensor board (2) from the system board. (The thermal sensor board is attached to
the system board with double-sided adhesive.)
3. Remove the thermal sensor board.
Reverse this procedure to install the thermal sensor board.
Bottom cover on page 27).
Spare part number
917887-001
Battery on page 29).
Component replacement procedures 33