HP EliteBook x360 1030 G2 Maintenance And Service Manual page 57

Fingerprint reader board
Description
Fingerprint reader board (includes double-sided adhesive)
NOTE: The fingerprint reader board spare part kit does not include the fingerprint reader board cable.
The fingerprint reader board cable is included in the Cable Kit, spare part number 917893-001.
Before removing the fingerprint reader board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
a. Battery (see
b. Solid-state drive (see
c. Fan (see
d. Speakers (see
e. System board (see
Remove the fingerprint reader board:
1. Detach the fingerprint reader board cable (1) from the keyboard/top cover. (The fingerprint reader
board cable is attached to the keyboard/top cover with double-sided adhesive.)
2. Remove the Phillips PM2.0×2.4 screw (2) that secures the fingerprint reader board and bracket to
the keyboard/top cover.
3. Remove the fingerprint reader board bracket (3).
Bottom cover on page
Battery on page 29)
Solid-state drive on page
Fan on page 34)
Speakers on page 35)
System board on page
27), and then remove the following components:
30)
43)
Component replacement procedures
Spare part number
917891-001
49