Approvals - Siemens SCALANCE X-000 Operating Instructions Manual

Approvals

The SIMATIC NET products described in these Operating Instructions have the approvals
listed below.
Note
Issued approvals on the type plate of the device
The specified approvals apply only when the corresponding mark is printed on the product.
You can check which of the following approvals have been granted for your product by the
markings on the type plate.
Unless mentioned otherwise, the following approvals apply to all variants of the SCALANCE
X-000.
Notes for the manufacturers of machines
The devices are not machines in the sense of the EC Machinery Directive. There is therefore
no declaration of conformity relating to the EC Machinery Directive 2006/42/EC for these
devices.
If the devices are part of the equipment of a machine, they must be included in the
declaration of conformity procedure by the manufacturer of the machine.
See also
SIMATIC NET Industrial Ethernet TP and Fiber Optic Networks
(http://support.automation.siemens.com/WW/view/en/8763736)
Installation guidelines
The devices meet the requirements if you adhere to the installation and safety instructions
contained in this documentation and in the following documentation when installing and
operating the devices.
● "Industrial Ethernet / PROFINET Industrial Ethernet" System Manual
● "Industrial Ethernet / PROFINET - Passive network components" System Manual
You will find information on the system manuals in the section "Auto-Hotspot", in "Further
documentation".
● "EMC Installation Guidelines" configuration manual
60612658 (http://support.automation.siemens.com/WW/view/en/60612658)
SCALANCE X-000
Operating Instructions, 09/2016, C79000-G8976-C344-02
8
39