Select The Paper Size And Type With User Tools; Select "Architecture" Or "Engineering" (Na Only) - Ricoh Aficio 240W Service Manual

COPIER INSTALLATION

Select "Architecture" or "Engineering" (NA Only)

Check the User Tool setting to determine whether "Architecture" or "Engineering" is
selected for automatic width detection.
1. Push the "User Tools" key
Features.
2. Push  to select "03 Orig. Paper Size".
3. Select "Engineering" or "Architecture" (whichever is used most frequently by the
operator).

Select the Paper Size and Type with User Tools

1. Push the "User Tools" key
Features.
2. Push  to select "04 Tray Paper Size".
The "1 Bypass Tray" selection is shown with the selections for each installed
paper supply option. Selections are shown only for installed options.
If you installed all the options, you will also see "2 Paper Roll 1, 3 Paper Roll 2",
and "4 Cut Paper Tray".
If selections for the installed options are not shown:
• Do the procedure in the section immediately before this to enable the paper
feed options.
• Make sure that you switch the main power switch off then back on to enable
the paper feed options.
• If you did not switch the main power switch off then back on to enable the
selections done for SP1960, the selections for paper size will not be shown.
3. To set the paper size for the manual feed table and each option:
1) Push the applicable number on the 10-key pad.
2) Push the right or left arrow key to highlight the applicable size.
3) Push the key below "OK". The display changes to the one that was shown
before.
4) Do this procedure again until the paper sizes for each paper supply option
are set.
4. Push the key below "Prev Menu", then push the key below "Next".
5. Push  to select "05 Tray Paper Type"
6. To set the paper type for the manual feed table (bypass tray) and each option:
1) Push the applicable number on the 10-key pad.
2) Push the right or left arrow key to highlight the applicable size.
3) Push the key below "OK". The display changes to the one that was shown
before.
4) Do this procedure again until the paper types for each paper supply option
are set.
B125

then select  "System Settings">  "General

then select  "System Settings">  "General
1-20 SM