Panasonic KX-TD816 Installation Manual page 6

Attention
• Keep the unit away from heating appliances and electrical noise generating devices such as
fluorescent lamps, motors and televisions. These noise sources can interfere with the
performance of the Digital Super Hybrid System.
• This unit should be kept free of dust, moisture, high temperature (more than 40 °C) and
vibration, and should not be exposed to direct sunlight.
• Never attempt to insert wires, pins, etc. into the vents or other holes of this unit.
• If there is any trouble, disconnect the unit from the telephone line. Plug the telephone
directly into the telephone line. If the telephone operates properly, do not reconnect the unit
to the line until the trouble has been repaired. If the telephone does not operate properly,
chances are that the trouble is in the telephone system, and not in the unit.
• Do not use benzine, thinner, or the like, or any abrasive powder to clean the cabinet. Wipe
it with a soft cloth.
• The ISDN Line Unit (e.g. KX-TD280) is in accordance with the European
Telecommunication Standards (ETS).
If your telephone company provides an ISDN service which follows the standards other
than ETS, some ISDN features in the Features Guide may not work properly. (e.g. Charge
Fee Reference, CLIP, COLP, etc.)
• The primary Rate Interface ISDN Expansion Unit (KX-TD290) is working in PCM30 mode
only.
• To use the point-to-multi-point configuration with the KX-TD286, the number on the name
plate, which is on the back of the unit, must be
• To use the KX-TD170 or KX-TD174 with the KX-TD188 or KX-TD290, the number on
the name plate, which is on the back of the unit, must be
WARNING
• THIS UNIT MAY ONLY BE INSTALLED AND SERVICED BY QUALIFIED
SERVICE PERSONNEL.
• WHEN A FAILURE OCCURS WHICH RESULTS IN THE INTERNAL PARTS
BECOMING ACCESSIBLE, DISCONNECT THE POWER SUPPLY CORD
IMMEDIATELY AND RETURN THIS UNIT TO YOUR DEALER.
• DISCONNECT THE TELECOM CONNECTION BEFORE DISCONNECTING
THE POWER CONNECTION PRIOR TO RELOCATING THE EQUIPMENT,
AND RECONNECT THE POWER FIRST.
• THIS UNIT IS EQUIPPED WITH AN EARTHING CONTACT PLUG. FOR
SAFETY REASONS THIS PLUG MUST ONLY BE CONNECTED TO AN
EARTHING CONTACT SOCKET WHICH HAS BEEN INSTALLED ACCORDING
TO REGULATIONS.
• THE POWER SUPPLY CORD IS USED AS THE MAIN DISCONNECT DEVICE,
ENSURE THAT THE SOCKET-OUTLET IS LOCATED / INSTALLED NEAR THE
EQUIPMENT AND IS EASILY ACCESSIBLE.
6
or later.
or later.
Attention