3.
Turn over the unit again and remove the inside cover.
4.
Install the card, secure the screw (included with the unit) and connect the cable to the
connector.
Remote Card
5.
Flatten the cable to replace the inside cover properly.
6.
Replace the inside cover and secure the four screws on the back. Also, replace the side
cover.
7.
Set the MODE switch to 2.
MODE
1
2
8.
Replace the front cover.
9.
Install the unit to the main unit.
General Installation
Cable
Side View
DISA Card
2.4 Installation of Optional Cards and Unit
101