Danger Of Scald; Fire Disaster; Danger Of Mechanical - Konica Minolta KM256 Manual

1.6 Danger of scald

When the printer drying system is running at a high temperature, if you touch it, it may
cause burns. To avoid personal injury, please notice the following precautions:
Don't touch the inside printer drying system's cover. Even its power source is off, the
internal surface may still be very hot;
It should be particularly careful when touching the material drying channel.

1.7 Fire disaster

The temperature is high when the printer drying system is running. If the printer's
built-leakage circuit breakers (ground fault leakage protection) trip repeatedly, please call
your local dealer
To avoid the danger of fire disaster, please notice the following precautions:
Please use the power voltage specified on the nameplate.
To connect the power cord to dedicated circuit and in accordance with the rated
parameters of the wall outlet, using the branch circuit breakers protect each circuit.
Do not use a wiring board (inserted row) to connect two power cords.
Only use the power cord supplied with the printer by Printer. Do not use damaged
power cord. Do not use the power cord supplied with other products.
Do not put any objects into the printer slot.
Be careful not to spill liquid on the printer.
Do not use spray containing flammable gases inside or near the printer.
Do not block or block the opening of the printer.
Do not attempt to remove drying system or electrical control cabinet.
Loading the material which can work at the 125 ° C (257 ° F) and the combustion
temperature is higher than 250 ° C (482 ° F).

1.8 Danger of mechanical

The moving parts of printer may cause personal injury. To avoid personal injury when
working near the printer, please notice the following precautions:
To make sure all clothes and body parts away from moving parts of the printer;
Do not wear necklaces, bracelets and other hanging objects;
If your hair is long, please prevent it falling into the printer;
Be careful not to let the sleeves or gloves be entangled by moving parts of the printer;
Do not touch the gear or move the roll during printing.
3