Configuration File Menu - Walchem WebMaster ONE Instruction Manual

Gateway Port (only for VNet Activations)
Type the desired VNet port in the text box. This will normally not change from the default port of
1194.
Sub-Network Settings (only appears if the controller has master networking activated)
Mapped Internet IP Address
If you are accessing the master process monitor by using NAT to translate a real IP address to a
fake IP address, then type the real IP address into this field of the master process monitor.
Direct Modem Connection (Point-to-Point)
Minimum required direct modem rings
The modem will answer after 4-9 rings. The default value is 7. If this is a problem because the
phone system will not allow that many rings, type the new number into the text box.
Browser Settings
Java/Non-Java
If you are using Internet Explorer 7.0 or higher, or Mozilla Firefox, then Non Java should be
selected. Check the radio button for Java to use Java for viewing live data. The choice depends
upon the browser you will use. Java should only be selected if you are using Internet Explorer 5.0
or 6.0. You will need to have the Java Virtual Machine plug-in installed (available at
www.java.com).
6.48

Configuration File Menu

If many of your applications are nearly identical, you can save a lot of time in the set up by
downloading a typical configuration file to your hard drive, and later uploading the configuration
file to another controller.
NOTE: If the software version of the controller that the configuration file was exported from is
not the same as the controller it is imported to, the import will either fail, or not all settings will be
modified. Use the software version in the name of the configuration file and export a new file for
any new software version.
Export UCF
In order to transfer the User Configuration File (UCF) from the WebMasterONE to your
computer, click the Export UCF link. You will be presented with the standard Windows dialog
box to download a file. Click the radio button to Save this file to Disk, then click OK. Select the
location where you want the file to be saved, change the name of the file if desired, then click
Save. The file is only around 14KB, so it should be transferred relatively quickly. Click Close to
close the dialog box.
The exact sequence of events and wording within the dialog box will vary depending upon the
operating system (Windows 95, 98, NT, 2000, XP etc.) on your PC.
Browse
In order to transfer a previously saved UCF from your computer to this WebMasterONE, first
click the Browse button to locate the file on your computer. A "Choose File" dialog box will open.
Click on the correct file, then click Open.
146