Table of Contents
Advertisement
5.0
OPERATION
These units control continuously while power is applied. Programming is accomplished via the local
keypad and display.
To view the top level menu, press any key. The menu structure is grouped by inputs and outputs. Each
input has its own menu for calibration and unit selection as needed. Each output has its own setup menu
including set points, timer values and operating modes as needed. After ten minutes of inactivity in the
menu, the display will return to the summary display. Keep in mind that even while browsing through
menus, the unit is still controlling.
5.1
Main Menu
The exact configuration of your WDT controller determines which menus are available as you scroll
through the settings. Certain menus are only available if you select certain options.
Main Menu Top Level
Tower A
Tower B
Access Code
Datalog
Config
Upgrade
Inside Tower A and B menus
Conductivity A or B
Temperature A or B
Bleed A or B
Feed A or B
WM1 or WM2
Alarm
4-20mA A or B
The
NEXT
key travels forward through this list while the
Pressing
ENTER
The following menu descriptions work exactly the same way for cooling tower A as for cooling tower
B.
Only if advanced USB feature is in model code
Only if advanced USB feature is in model code
Only if Feed based on Water Contactor or Paddlewheel
Only if 4-20mA option board(s) installed.
will Enter the lower level menu that is currently displayed.
PREV
key travels backwards through the list.
12
Advertisement
Table of Contents
