Figure 46 Network > WAN > Advanced
The table below describes the labels on this screen.
Table 28 Network > WAN > Advanced
LABEL
Multicast Setup
Multicast
Auto-Subnet Configuration
Enable Auto-IP-
Change Mode
Apply
Cancel
Chapter 8 WAN
DESCRIPTION
Select IGMPv1/v2 to enable multicasting. This applies to traffic routed from the
WAN to the LAN.
Select None to disable this feature. This may cause incoming traffic to be dropped or
sent to all connected network devices.
Select this option to have the EMG2926-Q10A change its LAN IP address to either
10.0.0.1 or 192.168.0.1 as needed when the EMG2926-Q10A gets a dynamic WAN IP
address in the same subnet as the LAN IP address 192.168.0.1 or 10.0.0.1.
The NAT, DHCP server and firewall functions on the EMG2926-Q10A are still available
in this mode.
Click Apply to save your changes back to the EMG2926-Q10A.
Click Cancel to begin configuring this screen afresh.
EMG2926-Q10A User's Guide
76