Videotron EMG2926-Q10A User Manual page 142

Figure 103 Management > Remote Management > SNMP
The following table describes the labels on this screen.
Table 67 Management > Remote Management > SNMP
LABEL
SNMP Settings
Server Port
Server Access
Secured IP
SNMP Enable
Get Community
Set Community
System Location
System Contact
Trap Settings
Trap Enable
Trap Manager IP
Chapter 20 Remote Management
DESCRIPTION
You may change the server port number for a service if needed. However, you must
use the same port number in order to use the service for remote management.
Select the interface(s) through which a computer may access the EMG2926-Q10A
using the service.
Select All to allow all computers to access the EMG2926-Q10A.
Otherwise, check Selected and specify the IP address of the computer that can
access the EMG2926-Q10A.
Select this to allow a manager station to manage and monitor the EMG2926-Q10A
through the network via SNMP.
Enter the password for the incoming Get and GetNext requests from the
management station. The default is public and allows all requests.
Enter the password for incoming Set requests from the management station. The
default is public and allows all requests.
Specify the geographic location of the EMG2926-Q10A.
Enter the name of the person in charge of the EMG2926-Q10A.
Select this to have the EMG2926-Q10A send an SNMP trap to the specified IP
address when it receives the event. Deselect to disable this feature.
Type the IP address of the SNMP manager to which your SNMP traps are sent.
EMG2926-Q10A User's Guide
142