Videotron EMG2926-Q10A User Manual page 108

Figure 76 Network > NAT > Port Forwarding
The following table describes the labels on this screen.
Table 51 Network > NAT > Port Forwarding
LABEL DESCRIPTION
Default Server Setup
Default Server In addition to the servers for specified services, NAT supports a default server. A default
server receives packets from ports that are not specified on the Port Forwarding
screen. You can decide whether you want to use the default server or specify a server
manually.
Select this to use the default server.
Change to Server Select this and enter the server's IP address manually.
Service Name Select a pre-defined service in the second field beside Service Name. The pre-defined
service port number(s) and protocol will appear in the port forwarding summary table.
Otherwise, select User define and type a name (made up of up to 31 printable
characters) in the first field beside Service Name to specify this rule. You will need to
enter the port number(s) manually and select the IP protocol.
Service Protocol Select the transport layer protocol supported by this virtual server. Choose between
TCP, UDP, or TCP_UDP.
If you have chosen a pre-defined service in the Service Name field, this field will not be
available.
Port Range Type the first and last internal port number that identifies a service.
Translation Port Type the first and last external port number that identifies a service.
Range
Chapter 12 NAT
EMG2926-Q10A User's Guide
108