Note Shift - Yamaha STAGEA ELS-02 Owner's Manual

LAYER Page 1
These buttons switch the display.
1
1 LEVEL
Determines the output level of the Element.
Range: 0 – 127
2 NOTE LIMIT
Determines the lowest and highest notes in the range for
which the Element sounds.
The setting of the HIGH slider cannot be set lower than
that of the LOW slider. Some Elements are not affected by
this parameter.
Range: C-2 – G8
3 PAN
Determines the position of the Element in the stereo
image.
Range: L64 – R63
LAYER Page 2
1 2

1 NOTE SHIFT

Determines the pitch settings in semitones.
Range: -64 – +63
2 TUNE FINE
Determines the fine tuning.
Range: -64 – +63
2 3
3 4 5 6
3 ATTACK RATE
Determines how quickly the Element will reach its
maximum level after the key is played. Higher values
produce a faster attack.
Range: 0 – 127
Reference page
• Envelope Parameters (page 143)
4 RELEASE RATE
Determines how much time it takes for the level to reach
0 after the key is released.
Higher values make the time shorter.
Range: 1 – 127
5 CUTOFF FREQ.
Determines the cutoff frequency of the filter.
Range: 9600 – 24000 cent
6 RESONANCE
Determines the amount of resonance (harmonic
emphasis) applied to the signal at the cutoff frequency.
Some Elements are not affected by this parameter.
Range: 16 – 140
Filter — Cutoff Frequency and Resonance
Filter modifies the tone by cutting the output of a
specific frequency portion of the sound. This
Electone is equipped with a low pass filter, which
passes only those signals below the cutoff frequency
and cuts signals above the cutoff frequency.
Cutoff Frequency
Level
These frequencies are passed by the filter.
Level
Cutoff Frequency
You can produce a relatively brighter or darker sound
by setting the cutoff frequency.
Resonance is a parameter that boosts the level of the
signal in the area of the cutoff frequency. By
emphasizing the overtones in this area, this can
produce a distinctive "peaky" electronic tone.
ELS-02/ELS-02C Owner's Manual
Editing a Voice
Frequency
Resonance
Frequency
9
141