Using The Backlight - Nortel 2050 User Manual

Headset Disconnect
With Headset Disconnect enabled, the external lamp activates when the headset registers as
disconnected from the USB Headset Adapter.
To enable Headset Disconnect, select the cadence you want from the list. To disable Headset
Disconnect, select None.
Active Call
With Active Call enabled, the external lamp activates when the IP Softphone 2050 registers an
active call.
To enable Active Call, select the cadence you want from the list. To disable Active Call, select
None.
If you enable Active Call when the USB Headset Adapter is selected as the Ringing Speaker, then
the external lamp also activates on incoming calls.
Note: Any other application using the same audio channel as the USB
Headset Adapter also activates the external lamp.
Message Waiting
With Message Waiting enabled, the external lamp activates when the IP Softphone 2050 registers
a message waiting.
To enable Message Waiting, select the cadence you want from the list. To disable Message
Waiting, select None.
Priority
If more than one condition is enabled, then the external lamp activates according to the condition
with the highest priority. The priority of the conditions, from highest to lowest, is as follows:
• Manual Override
• Headset Disconnect
• Active Call
• Message Waiting

Using the backlight

The USB Headset Adapter uses a backlight to illuminate the buttons, letting you know when the IP
Softphone 2050 is running.
To enable the backlight, select Use backlight.
Chapter 9 IP Softphone 2050 Settings
IP Softphone 2050 User Guide
63