Unpacking And Initial Operations; Pre-Run Inspection - Windsor 1.005-297.0 Operator's Manual

Operations

Unpacking and Initial Operations

Open the shipping box on both sides, remove the
packaging material and roll the machine out of the box.
Fill the tank with water. You can add a cleaning solution
of your choice in a prescribed mixing ratio.

Pre-Run Inspection

Before each use, inspect the accessory such as the
pad driver for cracks, tears, or excess wear. If the
machine or accessory is dropped, inspect for damage
to install an undamaged accessory.
Repair the damaged machine before the next applica-
tion.
Tilt the head back and place the foot of the bumper on
the ground.Choose a pad for the appropriate applica-
tion. Center the pad on the driver plate.
Position the handle in a lower position.and push slowly
forward until the machine base tilts towards the ground.
Make sure to put the wheels back on the ground in time
to avoid the base from falling on the ground. This might
cause damage! Check to make sure the power switch
is in the "off" position.
Set the handle position to the desired height by pulling
and releasing the black knob with the left hand. While
holding the black knob out, raise or lower the handle
frame with your right hand.
To fix the handle frame into place, release the black
knob so that it locks firmly into one of the holes.
To turn the machine on, press the power button on the
end of the left handle.
Position "0" is off and position "I" is on.
Make sure a suitable pad or brush is mounted before
starting the machine. The immediate contact of the
floor and driver plate without a pad can lead to serious
damage of the floor and/or the machine.
8.638-856.0 Manual Operators - Radiant Orbital Scrubber 8