Table of Contents
Advertisement
Operations
Always store with the base in the upright position.
Lifting and Carrying
If you do not have a ramp, we recommend two people
to life machine in and out of a vehicle. Put the handle
into a firmly locked lower position. Make sure that the
machine base rests on a pad, so that the grip surface
of the driver plate does not get damaged or hooked
onto a carpeted surface.
When lifting the machine in or out of the vehicle, set the
wheels down first, followed by the machine base.
Make sure not to grip too close to the machine base. If
the base should flip upwards it can cause serious hand
injuries.
Make sure you lift the machine with a back-friendly
posture.
Secure machine firmly so it will not move.
Weight Kit Installation
The total weight of the weight kit is 40 lbs.
Put the weights on top of the mounting plates located
on the sides of the machine base.
Put the four screws into the holes provided on the
weight plates and fasten by turning clockwise.
Once the screws have threaded at least 5 full turns,
tighten the wing nuts by turning them clockwise, until
the weights fit securely to the base.
Make sure that the weights are securely attached to the
base. Loose weights can cause serious damage.
For storage and transport we recommend removing the
weight kit. The machine can be transported more easily
without the weights.
8.638-856.0 Manual Operators - Radiant Orbital Scrubber
10
Advertisement
Table of Contents
