Table of Contents
Advertisement
Operations
Attach a driver plate to the machine base by lining up
the holes of the driver plate with the appropriate
threads of the bearing retainer ring. It is recommended
to align the threads of the bearing horizontally to the
ground.
Put the four countersink screws through the holes of
the driver plate and first screw them into the bearing
retainer ring threads manually. Then, tighten the screws
with an electric screwdriver
• NOTE: Tighten the screws sufficiently to avoid disen-
gagement of the driver plate from the machine base
during operation.To avoid stripping the screws do not
over tighten. An electric screwdriver with a clutch will
ensure that stripping will not occur.
Accessories And Applications
Never store the accessories in wet conditions. Keep the
accessories away from extreme heat and from chemi-
cals.
Driver Plates
Exclusively use designed driver plates only. The use of
other driver plates will damage the machine and its
mechanical action.
The driver plates are fastened on the machine base
with four countersink screws.
Standard Driver Plate
The standard driver plate (17" in diameter) is supplied.
It is suitable for use with all pads for textile and hard
floor applications. The pads can be easily attached and
removed from the driver disc.
Never put the driver on the carpet without a pad
attached, as this might cause serious damage to the
floor.
8.638-856.0 Manual Operators - Radiant Orbital Scrubber
12
Advertisement
Table of Contents
