Table of Contents
Advertisement
Operations
Process of Cleaning
For effective floor cleaning, move the machine forward
and backwards. It is recommended to spray the floor
as you move the machine forward, releasing the spray
button when you move the machine backwards.
To increase the pressure and cleaning effect on certain
floor types like tile and grout, you can lift the machine
frame up, raising the wheels off the ground. When
lifting the wheels off the ground the full weight of the
machine lies on the machine base.
Make sure the surface the added pressure does not
damage floor.Omit this measure on very sensitive
floors.
End of the Application
Turn off the machine by putting the on/off switch to "O".
If a cleaning solution was used, fill solution tank with
water and spray out system for 30 seconds or drain
using draining port at bottom of tank.
Make sure to not let solution come in contact with the
motor.
Storage
To avoid damage to the handle frame, DO NOT lay the
machine frame on the floor as done with other
traditional cleaning equipment. Remove the pad from
the driver plate by pulling it down firmly. Put the
machine frame in an upright position by pulling the
black knob with the left hand and move the handle
frame upwards with the right hand. The black knob
should lock firmly in the top hole.
To allow an easy transportation of the machine, remove
the weight kit if used.
To easily roll the machine, push your foot on the back
wheel axle to create leverage and pull the handle
towards your body. The machine can be moved similar
to a dolly now.
9
8.638-856.0 Manual Operators - Radiant Orbital Scrubber
Advertisement
Table of Contents
