Table of Contents
Advertisement
Operations
Brush Installation
Put the machine base in an upright position, sitting on
the foot of the bumper.
Remove the driver plate by removing the four counter-
sink screws in the center of the plate using an electric
screwdriver.
It is important to only use a Number 3 Phillips head
screwdriver bit. Smaller bit sizes can damage the screw
heads and leave sharp edges, which can tear or snag
the pads. Damaged screws can cause further damage.
Mount the brush with the same countersink screws
used for mounting the driver plates.
NOTE: Tighten the screws sufficiently to avoid
disengagement of the brush from the machine during
operation
To avoid stripping the screws do not over tighten. An
electric screwdriver with a clutch will ensure that
stripping will not occur.
Attaching and Removing the Driver Plates
Put the machine base in an upright position, sitting on
the foot of the bumper. Remove the driver plate by
removing the four countersink screws in the center of
the plate using an electric screwdriver.
11
8.638-856.0 Manual Operators - Radiant Orbital Scrubber
Advertisement
Table of Contents
