Table of Contents
Advertisement
Installation
1. Disconnect power to the keypads by turning
off all circuit breakers connected to the
HomeWorks
processor or keypad link
®
auxiliary power supply.
WARNING: To avoid the risk of
electric shock, locate and lock
supply breakers in the OFF position
before wiring to terminal blocks.
Wiring with power on can result in
serious injury.
2. Address keypads. Assign a unique address to
each keypad using the DIP switch on the front
of the keypad. See Keypad Addressing (page
5) for DIP switch location and DIP switch
settings. Be sure to record the address for
future programming purposes.
Mounting Diagram
U.S. Backbox
63,5 mm (2
1
/
in) deep
2
Lutron Wallbox
P/N 241-218
Keypad
Mounting
Screws
Button Kit
3. Strip insulation from wires to 10 mm (3/8 in).
Each terminal will accept one or two 1,0 mm
(18 AWG) wires.
4. Connect wiring to terminal block as shown in
Wiring Diagram (page 6).
5. Mount keypad as shown in Mounting Diagram
(below). Do not over-tighten mounting
screws.
6. Restore power to the HomeWorks processor
and keypad link auxiliary power supply (if
used).
Faceplate
Adapter (4SN
model shown)
Faceplate (NI model shown)
3
2
Advertisement
Table of Contents
