Deck Adjustment - Samsung SC-D362 Service Manual

Alignment and Adjustments

3-3 Deck Adjustment

3-3-1 Operation Without Housing Assembly
1) Remove the Housing Ass'y from the Deck Ass'y.
2) Connect the Mechanical Chassis to the recorder
circuit to supply voltage.
3) Set to Unload mode.
3-3-2 Setting Mechanical Mode (Without Recorder Circuit)
1) Set the power-supply output to approx. 3V~5V.
2) Choose the polarity (depending on whether load-
ing or unloading).
3) Supply the voltage to the Motor Loading, and set
to the desired mode.
3-8
4) Press the S/W Push (Keep ON status)to start load-
ing, and push the PLAY Key.
(Cover the Top/End sensor with black tape,
because they do not operate.)
Note : For the removal of the Housing Ass'y refer to
4-2-2 (page 4-6).
SWITCH C-IN
Fig. 3-9
A
+
-
Fig. 3-10
Connceted the Recorder Circuit
<Table 3-4>
B Movement of Chassis
- Unloading
+ Loading
A
B
Samsung Electronics