Disassembly and Reassembly
4-2-4 Arm Tension Ass'y, Reel Disk S
4-2-4(a) Disassembly
Note 1 : When disassembling, take care not to deform
the part. Do not stain the post.
1) Separate the Spring Tension Œ from Hook of Sub
Chassis.
2) Remove the Washer Slit ˇ, and then lift up the Arm
Tension ¨.
3) Lift up the Reel Disk S ˆ.
SPRING TENSION Œ
SUB CHASSIS HOOK ´
4-10
WASHER SLIT ˇ
PIN Ø
Fig. 4-10 Arm Tension Ass'y, Reel Disk S
4-2-4(b) Reassembly
1) Mount the Reel Disk S ˆ.
2) After pushed Arm Tension Ass'y ¨ in the direction
"A", and then insert into the Pin Ø.
3) Insert the Washer Slit ˇ, and then hang the Spring
Tension Œ to Sub Chassis Hook ´ and Arm Tension
Hook ∏.
Note 1 : When reassembling or dsiassembling,
position of Spring Tension Œ is same.
Note 2 : When moving inspecting, must be inspect
Back Tension.
Note 3 : When reassembling, confirm that pin of Arm
Tension insert into the Guide Cam.
∏ ARM TENSION HOOK
¨ ARM TENSION ASS'Y
ˆ REEL DISK S
Samsung Electronics