OSEE PRM1014 User Manual page 50

Functionality of the Main Menu
 Method 2: By function key.
Set PBP function to a function key (F1~F5). Select the menu item
FUNCTION KEY F1 for example, and assign its sub-item value as
PBP, as shown in Figure 5.1-26:
Figure 5.1-26 Set the Function Key as PBP
(3) Scope for the signal source of the slave picture
The selection scope of the signal source for the slave picture will be
changing with the main picture's source, as shown in Table 5.1-9:
Table 5.1-9 The Relationship of the Signal Source for Slave Picture and
Signal Source for Main
Picture
\ Signal Source for
Slave Picture
SDI1
SDI2
LINE1(CVBS)
LINE2(CVBS)
HDMI
 Position for signal source: The input signal information of the main
picture displays at the top left corner of the screen, and the one of the
slave picture displays at the top right corner of the screen.
 Settings for signal source: Press INPUT button to set the signal
source for the main picture, and select CONFIGSUB IN TYPE menu
item to set the signal source for the slave picture.
Auto Standby
2.
The Auto Standby function is used to set the status of the monitor when
the Power button is turned on or off.
 ON: AUTO STANDBY is set to ON to enable the auto standby mode.
Thus, the auto standby will be activated when detecting no signal input
or signal disappeared, and there will be a prompt during the process,
as shown in Figure 5.1-27:
FUNCTION
F1 PBP
F2 WIN SELECT
Main Picture
SDI1 SDI2 LINE1(CVBS)
 

 

  
  
  
44
PBP
MAIN
LINE2(CVBS) HDMI
 
 
 
 


WFM




