Troubleshooting; Starter Motor Will Not Crank The Engine; Engine Will Not Start; Engine Starts But Will Not Shift Into Gear - Mercury 200 Verado FourStroke Operation, Maintenance & Warranty Manual

Including pro series
Hide thumbs Also See for 200 Verado FourStroke:
Table of Contents

Advertisement

Starter Motor Will Not Crank the Engine

POSSIBLE CAUSES
Lanyard stop switch not in RUN position.
Blown 5‑amp fuse. Check DTS power harness circuit fuse. Refer to
Maintenance section.
Outboard is not shifted to neutral position.
Shift actuator failure. "Gear Shift Diff" error message shown on
VesselView.
Weak battery or battery connections are loose or corroded.
Ignition key switch failure.
Wiring or electrical connection faulty.
Starter motor solenoid or slave solenoid failure.

Engine Will Not Start

POSSIBLE CAUSES
Incorrect starting procedure. Refer to Operation section.
Old or contaminated gasoline.
Fuel is not reaching the engine.
• Fuel tank is empty.
• Fuel tank vent not open or restricted.
• Fuel line is disconnected or kinked.
• Fuel filter is obstructed. Refer to Maintenance section.
• Fuel pump failure.
• Fuel tank filter obstructed.
Ignition system component failure.
Spark plugs fouled or defective. Refer to Maintenance section.

Engine Starts But Will Not Shift Into Gear

Shift actuator failure. "Gear Shift Diff" error message shown on
VesselView.

Engine Runs Erratically

POSSIBLE CAUSES
Overheating ‑ Warning horn not working.
Low oil pressure. Check oil level.
Spark plugs fouled or defective. Refer to Maintenance section.
Incorrect setup and adjustments.
Fuel is being restricted to the engine.
a. Engine fuel filter is obstructed. Refer to Maintenance section.

TROUBLESHOOTING

120
eng

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents