Creating Your Own Program; Program Play - Sony CMT-M700DVD Operating Instructions Manual

Creating your own
program

— Program Play

You can make a program of up to 25 steps.
Using the front panel display
1
Press FUNCTION repeatedly to switch
the function to DVD.
2
Press PLAY MODE/TUNING MODE on
the remote in stop mode repeatedly
until "PGM" appears.
3
Press DVD . or > on the remote
repeatedly until the desired title or
track number appears.
When programming a DVD, press ENTER/
YES on the remote, then press DVD .
or > on the remote repeatedly until the
desired chapter number appears.
PGM
Selected title or track number
4
Press ENTER/YES on the remote.
The title/chapter, or track is programmed.
The step number appears, followed by the
last programmed title or track number.
If you made a mistake, you can clear the last
step from the program by pressing CLEAR
on the remote.
PGM
Last programmed title
or track number
GB
14
L-SYNC
CD
MIN SEC
L-SYNC
CD
Total playing time
5
To program additional tracks, repeat
steps 3 and 4.
6
Press DVD N on the remote.
Other operations
To
Do this
Cancel Program
Press PLAY MODE/TUNING
Play
MODE on the remote in stop
mode repeatedly until both
"SHUF" and "PGM" disappear.
Check the Press DVD . or > on the
program order
remote repeatedly during Program
Play.
Add a track to
Perform steps 3 and 4 in stop
the end of the
mode.
program
Tips
• The program you made remains after Program Play
finishes. To play the same program again, press
DVD N on the remote. However, the program is
cleared when you open the disc tray.
• "---.--" appears when the total program time
exceeds 1000 minutes, or when DVD titles/chapters
are programmed.
Note
Depending on the DVD, you cannot use Program
Play.