Timer Recording Radio Programs - Sony CMT-M700DVD Operating Instructions Manual

7
Press MENU + or – on the remote
repeatedly until the desired sound
source appears.
Each time you press the button, the
indication changes cyclically as follows:
t TUNER y DVD PLAY T
t TAPE PLAY y MD PLAY T
8
Press ENTER/YES on the remote.
The start time, the stop time, and the sound
source appear in turn, before the original
display returns.
9
Press ?/1 to turn off the system.
Other operations
Do this
To
1 Press CLOCK/TIMER
Check the settings/
SELECT on the remote.
activate the timer
2 Press MENU + or – on the
remote repeatedly until
"DAILY SELECT?" appears,
then press ENTER/YES on the
remote.
Start over from step 1.
Change the setting
1 Press CLOCK/TIMER
Cancel the timer
SELECT on the remote.
2 Press MENU + or – on the
remote repeatedly until
"TIMER OFF?" appears, then
press ENTER/YES on the
remote.
Notes
• You cannot activate the Daily Timer and recording
timer at the same time.
• If you use the Daily Timer and the Sleep timer at
the same time, the Sleep Timer has priority.
• Do not operate the system from the time the system
turns on until the play starts (about 30 seconds
before the preset time).
• If the system is on about 30 seconds before the
preset time, the Daily Timer will not be activated.
• You cannot use the optional component connected
to ANALOG IN jacks or DIGITAL OPTICAL IN
jack as the sound source for Daily Timer.
Timer recording radio
programs
To timer record, you must first preset the radio
station (see "Presetting radio stations" on page
60) and set the clock (see "Setting the clock"
on page 11).
1
Tune in the preset radio station (see
"Listening to the radio" on page 61).
2
Press CLOCK/TIMER SET on the
remote.
3
Press MENU + or – on the remote
repeatedly to select "MD REC SET?" or
"TAPE REC SET?", then press ENTER/
YES on the remote.
"ON" appears and the hour indication
flashes.
4
Set the time to start recording.
Press MENU + or – on the remote
repeatedly to set the hour, then press
ENTER/YES on the remote.
The minute indication flashes.
Press MENU + or – on the remote
repeatedly to set the minute, then press
ENTER/YES on the remote.
5
Set the time to stop recording following
the same procedure as step 4.
6
When you record on an MD, press
MENU + or – on the remote repeatedly
to select the recording mode (e.g., LP2,
LP4), then press ENTER/YES on the
remote.
The timer recording settings appear, then
the original display returns.
7
Load a recordable MD or tape.
8
Press ?/1 to turn off the system.
continued
GB
69