H3C WA2110-AG Quick Start Manual page 16

CAUTION:
To avoid connection interference caused by dust, clean the pins of the
•
cable connector before connecting the cable to the access point.
Discharge the cable before connecting it to the access point.
•
WARNING!
In the case of lightning, do not plug/unplug the cable to/from the
•
access point.
When the LEDs of the access point are blinking, do not plug/unplug
•
the cable to/from the access point or perform any operation that may
affect the normal running of the access point.
Align the bottom of the access point with the mounting bracket, and
5.
press the access point backward. Thus, the access point is mounted in
the mounting bracket properly.
WARNING!
To avoid physical damage to the access point, do not mount or dismount
the access point with excessive force.
To prevent the access point from being stolen, insert the locking bar (as
6.
shown in (1) of
bracket. Push the locking bar through the opening until the hole on the
locking bar is exposed. Insert the shackle of a lock through the hole on
the locking bar to lock the access point with the mounting bracket, as
shown in (2) of
Figure 5 Lock the access point with the mounting bracket
Figure 5) into the opening at one side of the mounting
Figure 5.
10