H3C WA2110-AG Quick Start Manual page 14

Remove the access point from the mounting bracket.
1.
Route the Ethernet cable and, if you are using a power adapter, the
2.
power cable on the back of the mounting bracket, as shown in
CAUTION:
For easy installation and removal of the access point from the
•
mounting bracket, make sure that there is sufficient flexibility with the
cable and that the cable is long enough. If not enough cable is routed
through the back of the mounting bracket, or the cable is inflexible, it
can be difficult to install or remove the access point from the mounting
bracket.
It is recommended to use flexible cables.
•
Figure 3 Cabling on the back of the bracket
Mount the bracket to a wall or ceiling, as shown in
3.
8
Figure
Figure 4.
3.