Inserting And Removing Sd Cards; Inserting Sd Cards; Removing Sd Cards; Using The Security Screw - Tascam SS-CDR250N Owner's Manual

Inserting and removing SD cards

Inserting SD cards

Insert an SD card into an SD card slot on the front of the unit to
enable playback and recording by this unit.
NOTE
SD cards can be inserted whether or not the unit is on or off (in
standby).
1.
Pull the SD card slot cover forward to open it.
2.
Inserted SD cards with the correct orientation.
The label should be up and the connector should be insert-
ed toward the back.
3.
Close the card slot cover.
NOTE
If the SD card slot cover cannot be closed, remove the SD
card and insert it again.
3 – Preparation

Removing SD cards

Turn the unit off or stop operation before removing an SD card.
CAUTION
Never remove an SD card from the unit when it is being ac-
cessed, such as in the cases listed below.
Doing so could cause proper recording to fail, recorded data
to be lost, and sudden loud noises from monitoring equip-
ment, which might damage the equipment, harm hearing or
cause other trouble.
Moreover, removing a card during FIRMWARE UPDATE execu-
tion could result in the unit becoming unable to start up or
operate properly.
o When recording
o During playback
o During SYSTEM BACKUP IMPORT or EXPORT execution
o During FIRMWARE UPDATE execution (See "Firmware up-
date procedures (USB flash drives and SD cards only)" on
page 101.)
o When the BROWSE screen is open and the SD card is being
accessed
1.
Pull the SD card slot cover forward to open it.
2.
Press the SD card in gently to make it to come forward.
3.
Pull the SD card out by hand.

Using the security screw

You can use the included security screw to lock the card slot cov-
er switch.
Use a Phillips (+) driver to install/remove the security screw.
TASCAM SS-CDR250N / SS-R250N
27