Table of Contents
Advertisement
SETTING "COOK BY WEIGHT" CODE
This code is for roasting meats in the microwave. Its
Meat-roast weights in about 3 to 6 pound range
automatically-set times and power levels give better
microwave best, although COOK BY WEIGHT code
results than microwaving at one power only,and it is
allows setting lower or higher weights than 3-6 lb.
easier to microwave meat with this setting than with
Depending on code, two beeps signal error in setting
cookbook instructions because you do not have to
too-high weight.
calculate "minutes per pound" cooking times. As
"Cook by Weight" preprograms oven to stop after
soon as you enter the code (which tells oven the
type of meat) and the weight, oven calculates
partial cooking, so meat won't ovemook on one side.
Turn meat over, then touch START to continue
cooking time.
cooking.
Meat must be defrosted and at refrigeratedtemp-
erature to correspond with preset times in this code.
R.IB ROAST
_--/_f--/ ,--
OZ
P
"
4. Enter weight. Word prompt
"_"
3. Check weight of meat. Weight
ENTER shows in display and
must be in pounds and
O'sshow where LB and OZ
1. Touch COOK BY WEIGHT
ounces. If label gives weight in
should be entered. LB flashes
pad. Word prompt shows
pounds only (Ex: 3.28 pounds),
until you enter pound(s) by
ENTER CODE on display,
change the fraction of a pound
touching correct number pad.
(the numbers after the decimal
When pound(s) has been
2. Select desired code from 1
point) to ounces using chart on
entered, LB will stop flashing
through 6_Doorframe (open
opposite page. (Ex: 3.28 Ibs.
and OZ will flash. Example: fo, _
the door to view) and chart at
converts to 3 lb. 05 oz.)
3 pounds, 5 ounces, touch 3
right describe types of food for
(lb.), 0 (first digit of ounces),
then touch 5. As soon as all
each code. Enter the one-digit
code by touching the correct
these digits have been set,
number pad.
display will immediately show
cook time.
Ounce weights less than 10
must be preceded by a 0
_
(Example: for 8 ounces, touch
1
2
3
0 (lb.), 0 (first digit of ounces),
then touch 8. As soon as three
4
5
6
digits are set, display immedi-
,7
8
9.
ately showscook time.
5. TouchSTART/STOPto start
6. After partial cooking, oven
7. After total cooking time, 4 long
oven. CODE flashes in display
beeps twice and stops. Interior
beeps sound and END appears
as time counts down. Interior
light goes off but time remains
in display, Touch RESET or
light goes on and fan sound is
on the display. Stop is to
open oven door to clear END
heard. Turntable rotates unless
prevent meat's overcooking on
before starting another cooking
manually turned off by
one side before turning over.
function. Let roast stand few
touching TURNTABLE pad.
After turning meat over, touch
minutes before carving (see
(Turn off Turntable pad for
STARTto resettime on display
chart and tips opposite page).
large, oblong dishes which
and finish cooking.
could drag.)
When oven switches power levels, you may observe
change in lighting intensity and/or change in blower sound.
14
This is normal.
Hide quick links:
Advertisement
Table of Contents
