Specifications - Central Machinery 91130 Owner's Manual

Specifications

Setup - Before Use:
Read the ENTIRE IMpORTANT SAFETy INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION: Turn the power Switch of
the tool off and unplug the power cord before performing any procedure in this section.
Note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagrams near the end of this manual.
Support Stand Assembly/Mounting
1. Place one Tray (6) upside down on a level
surface. Attach Support Legs (5) to each outside
corner of the Tray using twelve M5 x 1 2 Bolts (7),
M5 Washers (3), and M5 Lock Nuts (4). Attach
remaining Trays to Support Legs using Bolts,
Washers, and Lock Nuts. Refer to Figure A and
Support Stand Assembly Diagram on page 19.
2. Hold the Foot Support (2) and Floor Mounting
Bracket (8) together, making sure to align
mounting holes. Align Foot Support and Floor
Mounting Bracket with the three mounting
holes on each Support Leg, and secure using
M5 x 1 2 Bolts (7), M5 Washers (3), and M5 Lock
Nuts (4). Refer to Figure A and Figure B.
3. With assistance, turn the assembled
Support Stand right side up.
4. If mounting Support Stand to floor, bolt down using
four Floor Mounting Brackets. Secure in place using
bolts (not included) through holes on Brackets.
Item 91130 For technical questions, please call 1-888-866-5797.
Support Leg
Figure A
Floor mounting
hole
Floor
Mounting
Bracket
Foot
Support
Figure B
Foot
Support
Tray
Page 7