Specifications; Setup; Operation - Central Machinery 39955 Owner's Manual & Safety Instructions

Specifications

Electrical Rating
Spindle No Load Speeds
Spindle Stroke
Spindle
Swing
Column Diameter
Chuck Capacity
Max. Spindle to Base
Spindle to Table
Table
Wet Table
Table Slot
Setup - Before Use:
Read the ENTIRE IMpORTANT SAFETy INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Turn the power Switch of the tool off and unplug the tool from its electrical
outlet before performing any procedure in this section.
Note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
Mounting
Secure the tool to a supporting structure before use.
Before assembly, bolt the Base to a flat, level,
solid floor location capable of supporting the
weight of the drill press and any workpieces.
Assembly
column Assembly to Base
1. With the Base (10B) on a flat level surface,
bolt on the Column Support (3B) using the four
M12 Hex Head Screws (9B). Tighten Firmly.
Page 6
120VAC / 60Hz / 13.5A
180, 310, 320, 500, 540, 570, 1180,
1565, 1805, 2190, 2795, 3865 RPM
4-3/4"
MT3
20"
3-5/8"
5mm to 20mm (.197" to .787") JT3 Taper
45-1/4"
26-1/8"
18-3/4" x 16-3/4"
With Oiler
1" x 1/2"
For technical questions, please call 1-888-866-5797.
Verify that installation surface has no hidden
utility lines before drilling or driving screws.
2. Insert the Column (11B) into its support and
firmly secure this assembly in place with
the Hex Socket set Screws (7B). It may be
necessary to unscrew the Hex Socket Screws
(7B) slightly to ensure that they do not protrude
internally, as this will prevent the Column
from sliding fully into position in the Tube.
Item 39955